Pose Converter/Builder isn't working?
I purchased the G3 pose converter/builder a while back and it worked pretty good aside from a few minor adjustments (which is to be expected) but lately when I try to use my G2 poses with it, the poses are coming out pretty wonky. It's like it decided not to work anymore. Has anyone else run into this? Should I delete my converted poses folder and convert them again? Any info would be appreciated.
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2025 Daz Productions Inc. All Rights Reserved.
Comments
Anyone? Any advice?
Did you accidently try to convert poses that you already converted to G3?
I don't think so. When I open it, it automaticlly goes to my "Converted" folder. Should I just delete those files and convert them all again? Kinda start from scratch?
There is a thread in the commercial section for this product. check in over there and they should be able to help you trouble shoot. http://www.daz3d.com/forums/discussion/51586/pose-builder-pose-converter-support-thread-commercial#latest