Loading...
> >

no subdivision in Wolf 2.0 by AM

darktornado18darktornado18 Posts: 4
in New Users

Hello everyone
I purchased the model "Wolf 2.0 by AM"

I saw the model "smoothed" How do I transfer the model to its most basic wire?

Comments

  • Richard HaseltineRichard Haseltine Posts: 102,865

    In the Parameters pane go to the Mesh Resolution group and set Resolution Level to Base.

  • darktornado18darktornado18 Posts: 4

    I change this basic but does not change the model
    The wire is still a smoothed model

  • Richard HaseltineRichard Haseltine Posts: 102,865

    Are you wanting to see the facets? That is a shading property - open the Surface pane, if it isn't, switch to the Editor tab, and select all surfaces by clicking on the wolf's name in the list, then turn smoothing off in the list of properties.

  • darktornado18darktornado18 Posts: 4
    Richard Haseltine said:

    Are you wanting to see the facets? That is a shading property - open the Surface pane, if it isn't, switch to the Editor tab, and select all surfaces by clicking on the wolf's name in the list, then turn smoothing off in the list of properties.

    i want see low poly model...

  • Richard HaseltineRichard Haseltine Posts: 102,865

    Base resolution is as low as it goes - anything further would require mesh reduction or retopology tools (it is a separate purchase, but DS has the Decimator plug-in for mesh reduction though it won't give a clean polygon flow).

Sign In or Register to comment.