TurboLoader Morph List Reset?

Elemental Flame

I used RiverSoft Art's TurboLoader pretty extensively to tone down my morphs a lot and make loading figures faster. I then use the TurboLoader Booster Utilities to load morphs on demand when I am loading a figure that has morphs I've disabled. It really was a game changer.

My problem is that I've been away from Daz for a while and picked it back up again recently. When I attempted to load a figure with TurboLoader to enable to morphs in the save it was not working. I then ran the manager for Genesis 8 and my morph list was gone. It prompted me to scan for morphs, which I did, but it only found the morphs I typically kept enabled; a very short list compared to the number I own. The long list of morphs I had disabled were nowhere to be found.

Is there some type of way for me to have TurboLoader scan my directories and find the morphs that it disabled so I can enable them again? Right now I'm working with a fraction of the content I actually own. Any help would be greatly appreciated!

felis

Riversoft has a commercial/support thread for each Turboloader, e.g. for G8 https://www.daz3d.com/forums/discussion/557186/released-turbo-loader-for-genesis-8-and-8-1-commercial/p17

 

crosswind

You can try: Under Product tab, 1stly click Clear Filters button, then click Scan for Morphs

Elemental Flame

crosswind said:

You can try: Under Product tab, 1stly click Clear Filters button, then click Scan for Morphs

That was producing the same short list of morphs, unfortunately. I reached out to Mr. Art in the proper thread though -- thank you!