Loading...
> >

https://www.daz3d.com/inflatable-water-float-poses-for-genesis-9-8-and-81-female Inflatable posing?

PitmaticPitmatic Posts: 891
edited August 4 in The Commons

Hi

I splashed out (see what i did there) on the https://www.daz3d.com/inflatable-water-float-poses-for-genesis-9-8-and-81-female and was under the impression that the inflatable had poses to match the figures poses but it seems not or am i doing something totaly wrong? I am setting collision on the inflatable to my figure but that just makes the inflable want to wrap the figure.

 

Post edited by Pitmatic on

Comments

  • frank0314frank0314 Posts: 14,019

    It says they are included. How did you install it? Where are you looking for the poses?

  • felisfelis Posts: 4,273

    Are the poses hieracical?

    And is either the character parented to the prop or reverse?

  • PitmaticPitmatic Posts: 891

    There are poses for the figures applying these to a figure works fine the content shows morphs for the inflatable all these do is adjust the seam of the inflatable

    I have a different project rendering at the moment so cant check again right now but i tried parenting the inflatable to the figure and applying the pose to it and the figure to the inflatable but no joy

  • lou_harperlou_harper Posts: 1,163

    My guess is that you load the figure, apply the pose. Load the the inflatable and dial in the matching morph. Just load both of them where they go by default, don't move them at this point. They should line up. Then you can group them and move the group where you want it. No need to parent.

  • PitmaticPitmatic Posts: 891

    Right figured it out it all boils down to my inability to read the tiny captions there is a big list of poses followed by a list of poses for the prop feel slightly foolish now.

  • felisfelis Posts: 4,273

    You got it solved, so all good.

Sign In or Register to comment.