Kinda Basics... but...
evilded777
Posts: 2,440
I've got an obj that's a pair of shoes. I'm trying to use Studio/Hexagon bridge to get them to line up with Genesis 8 Male so I can use the Transfer Utility.
Problem is, they are a pair in a single OBJ, so I can't manipulate each shoe into position seperately.
Is there a way to either split these into seperate objects and then re-group them after I have postioned them? Any advice or suggestions appreciated.
I've already done this with a model that was already seperate.
HexCapture.JPG
1058 x 691 - 57K
Post edited by evilded777 on
Comments
Can't you just marquee select them and stransform them or cut-and-paste them to a new object layer?
Treat each shoe as its own model, Left and right,