Loading...
> >

Daz Horse 3 mane and tail?

LunaseasLunaseas Posts: 6
in The Commons

I bought the Daz 3 horse but it doesn't seem to have a mane and tail? 

Comments

  • miladyderyni_173d399f47miladyderyni_173d399f47 Posts: 1,855

    I don't have Horse 3, but if it's set up like Horse 2, the mane and tail are separates that should be somewhere in the folder.

  • LunaseasLunaseas Posts: 6

    I'm not seeing it.

  • TaozTaoz Posts: 9,971

    Here are all the paths:

    daz-horse3-paths.png
    548 x 230 - 17K
  • TaozTaoz Posts: 9,971
    edited February 2023

    If you load it from the Characters folder it has both mane and tail:

     

     

    daz-horse3-full.png
    1352 x 812 - 298K
    Post edited by Taoz on
  • CybersoxCybersox Posts: 9,078

    You can also load them through the wearables options... Characters/Daz Originals/Horse-Thoroughbred Coat -Wearable ... but keep in mind that DH3 only comes with dForce mane and tail, and it's only visible without rendering if you have the parameters set to see them

    • Parameters > Simulation > Preview PR Hair: On
    • Parameters > Line Tessellation > Viewport Line Tesselation Sides: set it at least to 1

    More on this at https://www.daz3d.com/forums/discussion/447241/i-can-t-see-dforce-hair-in-iray 

    And, of course, if you're looking for a posable conforming mane and tail, you're out of luck.  Hopefully some PA will either make a set specifically for DH3 or someone will make a fit for the DH2 or Hivewire Horse manes... 

     

Sign In or Register to comment.