Loading...
> >

issue in Body Chains 3 for Genesis 3 and 8.1 Females

ironcheeseironcheese Posts: 72
edited March 2022 in Technical Help (nuts n bolts)

Hello, I have purchased the "Body Chains 3 for Genesis 3 and 8.1 Females" by Sshodan.
When I try to fit any of the Genesis 8.1 Female items in the purchase to a Genesis 8.1 Female, I get the error "You have chosen to fit an unsupported item to the figure", as if the itemfor G8F was not for G8F.
Then if I inspect the product, the node name in fact shows a reference to G3F, for example "Genesis3Famle_StoneChain_Chest_210819".
This is true for almost all of the Genesis 8.1 Female items in the purchase, a few work as usual.

I have opened a ticket, but maybe if Sshoban reads these forum posts will be easier to solve this one...

is there anything I can do to fix the issue myself or do i need the vendor?


Thank you

ATT01.JPG
280 x 233 - 21K
ATT02.JPG
488 x 303 - 35K
Post edited by ironcheese on

Comments

  • felisfelis Posts: 4,297

    I would assume that there are 2 products, one for G3F and one for G8.1F.

    Are you using the right?

  • ironcheeseironcheese Posts: 72
    edited March 2022

    felis said:

    I would assume that there are 2 products, one for G3F and one for G8.1F.

    Are you using the right?

    Yes, I am using the one in People/Genesis8F and I keep G3F and G8F in two separare libraries. I also tried swapping the two folders (in case the vendor had swapped them by mistake) and also I have redownloaded the product from scratch: same results.

    Post edited by ironcheese on
  • felisfelis Posts: 4,297

    What happen if you in Scene Identification change it to G8F instead of G8.1F?

  • ironcheeseironcheese Posts: 72

    felis said:

    What happen if you in Scene Identification change it to G8F instead of G8.1F?

    yep, just did it ... that was the issue... thank you

Sign In or Register to comment.