Loading...
> >

Sienna HD Leg Corruption when Kneeling

DarkRepastDarkRepast Posts: 223
in Technical Help (nuts n bolts)

I was working with this model: https://www.daz3d.com/sienna-hd-for-genesis-8-female

When setting her to pose in a kneeling position, her left leg becomes corrupted. See images. It specifically happens when bending her shin.

Any thoughts on how that's happened?

Corruption 1.jpg
965 x 1654 - 490K
Corruption 2.jpg
1249 x 1701 - 510K

Comments

  • DarkRepastDarkRepast Posts: 223

    I found the problem.

    The Flex Quad Left morph was set to 1300%.

    I'm not sure how that could've happened. Any thoughts on how it happened would be appreciated!

  • Richard HaseltineRichard Haseltine Posts: 100,765

    Does it happen again if you try with a fresh load of the figure in a new scene?

  • Seven193Seven193 Posts: 1,079
    edited September 2020

    I found these under the Genesis 8 base character install paths:

    data\DAZ 3D\Genesis 8\Female\Morphs\DAZ 3D\Base Flexions\pJCMFlexQuad_L.dsf
    data\DAZ 3D\Genesis 8\Female\Morphs\DAZ 3D\Base Flexions\pJCMFlexQuad_R.dsf

    data\DAZ 3D\Genesis 8\Male\Morphs\DAZ 3D\Base Flexions\pJCMFlexQuad_L.dsf
    data\DAZ 3D\Genesis 8\Male\Morphs\DAZ 3D\Base Flexions\pJCMFlexQuad_R.dsf

    Do these JCM morphs suddenly get activated for some unknown reasons?

    Post edited by Seven193 on
  • TheKDTheKD Posts: 2,691

    JCM get dialed in as the controlling joint is moved.

  • DarkRepastDarkRepast Posts: 223
    Richard Haseltine said:

    Does it happen again if you try with a fresh load of the figure in a new scene?

    No, it does NOT happen with a fresh load of the character.

     

    But even resetting the character didn't help.

  • DarkRepastDarkRepast Posts: 223
    TheKD said:

    JCM get dialed in as the controlling joint is moved.

    Why do you think it would go that crazy? 1300% seems unnecessary.

    Just curious! :)

  • Seven193Seven193 Posts: 1,079
    edited September 2020

    There's JCM flex morphs for the left and right leg.  Assuming all things equal, why is only the left leg going crazy?  Did somebody copy over the right morph file to the left, and forgot to edit the values?

    Post edited by Seven193 on
  • DarkRepastDarkRepast Posts: 223
    Dave230 said:

    There's JCM flex morphs for the left and right leg.  Assuming all things equal, why is only the left leg going crazy?  Did somebody copy over the right morph file to the left, and forgot to edit the values?

    I did some experimentation but I could not replicate the problem with a fresh scene. Chalk it up to a weird bug I guess?

    I'll say this, I showed my wife the screenies above and she was horrified :)

  • Seven193Seven193 Posts: 1,079

    I would make sure you didn't save any pose files while the flex quad morph was activated. It's possible that a bad value can be saved to file, so whenever you load the pose again, the bad value comes back like a nasty virus that was backed up.

Sign In or Register to comment.