Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2024 Daz Productions Inc. All Rights Reserved.
Comments
I had the same problem as the original poster. Victoria 4 Support Folder not found.
This was a clean reinstall of DAZ Studio and a new install of DIM. I checked the .bat file that is run during install and everything seemed to complete without error, but DS still could not load Victoria 4.2.
It turned out that the problem was the directory on my computer specified in DIM as the install directory (D:\DAZ 3D Library) needed to be added into the Content Directory Manager for DAZ Studio. I'm not sure why every other figure, except for Victoria 4.2, worked fine... but adding that directory fixed the problem.
I had the same issue. In my Content Library I only had My Daz Format mapped. My Poser Format was not mapped. I just mapped the My Poser Format to the same folder that My Daz Format was mapped to and viloa! Everything worked as expected. Hope this helps!